Your equipment arrives in our repair shop. It is then tagged with the part number and with any information from the customer. It is inspected and an estimated cost for repair will be given. The equipment is then disassembled and each part is inspected for wear or damage. All damaged parts are replaced. Each part is cleaned, refinished and prepared for reassembly. All soft parts (seals, o-rings and seats) are replaced. The equipment is then carefully reassembled. Every torch is reamed in preparation to receive a new tip and every regulator receives a new inlet nut and nipple. Equipment is tested following strict procedures for each type of equipment. Every regulator is pressure checked. Every torch is flame tested to insure proper working order. Dust seals are installed to keep contaminates out and the equipment is carefully packed and returned to the customer.